Find your parts diagram
Sticker on the pump body (the part with the basket), not on the motor. Motor labels from Century, A.O. Smith or Regal won't match parts.
Label on the side of the tank near the base. Size is in sq ft, e.g. 420 sq ft = C4030 or CCP420.
Rating plate inside the front access panel. Note the BTU and gas type (NG or LP).
Molded into the body or printed on top. Robotic cleaners: on the power supply.
Still not sure? Call (818) 818-6559 and we'll find it for you.
Other parts on the same Pentair Triton C Series Sand Filter
The Aladdin O-83 is a direct aftermarket replacement for Pentair part number 154492 , engineered as the 2-inch bulkhead standpipe O-ring for Pentair FNS Plus and Titan/Titan CM D.E. filter series. Seated at the filter's internal bulkhead standpipe connection, this O-ring creates the watertight seal that prevents water and D.E. powder from bypassing the filter grids and leaking internally, and a degraded or flattened bulkhead O-ring is one of the most common causes of D.E. powder returning to the pool after backwashing. The O-83 measures approximately 2-3/16 inches inside diameter, slightly under 2-1/2 inches outside diameter, and just over 3/32 inches in thickness, matching OEM dimensions precisely for a leak-free fit. It also cross-references Jandy/Zodiac part number R0792000 for additional compatibility across select Jandy filter models.
- Direct Pentair 154492 Replacement: The Aladdin O-83 is engineered to match the exact dimensions of the Pentair 154492 bulkhead standpipe O-ring — approximately 2-3/16 inches inside diameter, just under 2-1/2 inches outside diameter, and slightly over 3/32 inches thick — ensuring a precise, properly seated fit in Pentair FNS Plus and Titan/Titan CM D.E. filter models during seal replacement work.
- Stops D.E. Powder from Returning to the Pool: A worn or degraded bulkhead O-ring allows water to bypass the filter grid assembly and carry D.E. powder back into the pool after backwashing cycles, and installing a fresh O-83 restores the proper internal seal and addresses this common filtration complaint that points to bulkhead seal failure rather than grid issues.
- Cross-References Jandy/Zodiac R0792000: The O-83 is also listed as a confirmed replacement for Jandy/Zodiac part number R0792000, extending compatibility to select Jandy CL and DEV Series cartridge and D.E. filter models including the CL460, CL580, and DEV48, providing a single seal that addresses both Pentair and select Jandy filter platforms.
- Cost-Effective Aftermarket Sealing: The Aladdin O-83 delivers OEM-equivalent sealing performance at a significantly lower cost than the factory Pentair 154492 part, making it a budget-conscious yet reliable choice for both routine filter seal maintenance and reactive leak repair work performed by service techs and DIY pool owners alike.
- Pool-Grade EPDM Construction: Molded from pool-grade EPDM rubber that resists continuous pool chemical exposure, ongoing water pressure, and routine temperature variation, the O-83 maintains its elasticity and sealing performance throughout extended pool season use rather than hardening, cracking, or compressing out of shape under sustained service loads.
- Pentair Clean and Clear Plus Filter
- Pentair Quad DE Filters
- Pentair FNS Plus Filters





