Built InSet temperature, schedule, and switch heat or cool from the Moov Pool AI app.
Then Idle to Hold It. A single-speed heat pump this size would hammer your meter every time it kicked on. The TurboX 200K runs its compressor and fan across a continuous range instead. Cold water at the start of the season, it runs wide open at 200,000 BTU. Once the pool is at temperature it drops to a fraction of that and holds. At 50% capacity the COP is still 10.7, which is where it spends most of its life.
- 190,000 BTU in Smart mode, 152,000 BTU in Silence mode at 80°F
- COP 14 at full load, 10.7 at half load
- Runs down to 5°F air temperature
- Soft start, no inrush spike on the panel
Ends of the Season. Reversible refrigeration means the same unit that heats in March chills in August. 90,000 BTU of cooling at 95°F air pulls a large pool back from bathwater to swimmable. Titanium heat exchanger for salt and chlorine, galvanized steel cabinet for a commercial-grade shell, 2 inch unions, and the Moov Pool AI app for control from anywhere.
- 90,000 BTU cooling capacity
- Titanium exchanger, salt pool safe
- Galvanized steel casing, 2 in unions
- Wi-Fi app control, part of the Moov ecosystem
Pools from roughly 40,000 gallons up, and any pool that a 140,000 BTU unit would have to run at full speed to keep warm. That includes large in-ground pools, pool and spa combos on one heater, pools with water features, and light commercial pools. If your pool is under 40,000 gallons, the Moov X-Inverter or TurboX 145 will do the job for less. Ask us to size it.
No. That is the point of this unit. It runs on 208-230V single phase at 60 amps. Every other heat pump in this capacity range needs three-phase service, which most homes do not have and utilities charge heavily to add.
At a COP of 18 the TurboX puts out up to 18 units of heat for every unit of electricity it uses. A gas heater converts fuel to heat at roughly 0.85 to 0.95. Actual dollar savings depend on your electric and gas rates, but in Southern California the heat pump usually wins by a wide margin over a season, and it also cools, which gas cannot.
Moov rates it at 50 dB or less at 10 feet. That is comparable to a quiet conversation. Because it is a full inverter it spends most of its time at partial speed, where it is quieter still.
Usually, yes. Two 100K units add up to about the same capacity but need two breakers, two sets of plumbing, and two controllers that do not coordinate. One TurboX 200K on a single 60 A circuit replaces both with one set of unions and one app.
About 36 by 36 inches at the base and 58 inches tall, 500 pounds. It needs a level pad, clearance on all sides for airflow, and a top-discharge path clear above it. Plan for a forklift or four people to set it. Installation must be done by a licensed technician for the warranty to apply.
Questions & Answers
Have a Question?
Be the first to ask a question about this.
Los Angeles Local Installation Request
Need professional pool equipment installation in the Los Angeles, California area? We handle installation of heaters, pumps, filters, automation systems, and more. Fill out the form below, and we’ll contact you soon to schedule your local service!