Find your parts diagram
Sticker on the pump body (the part with the basket), not on the motor. Motor labels from Century, A.O. Smith or Regal won't match parts.
Label on the side of the tank near the base. Size is in sq ft, e.g. 420 sq ft = C4030 or CCP420.
Rating plate inside the front access panel. Note the BTU and gas type (NG or LP).
Molded into the body or printed on top. Robotic cleaners: on the power supply.
Still not sure? Call (818) 818-6559 and we'll find it for you.
On the Polaris Vac-Sweep 280 Pressure Cleaner diagram
This part
Open the full interactive diagram →
Other parts on the same Polaris Vac-Sweep 280 Pressure Cleaner
OEM Polaris Plastic Wheel Washer C64 is an essential part for maintaining the wheel assembly of Polaris 180 and 280 pool cleaners. This washer serves as a spacer and protective barrier, helping to keep debris out of the bearings while preventing over-tightening of the wheel lock screws. Each Polaris cleaner requires four washers per assembly to maintain smooth wheel rotation and system stability. Made from high-grade plastic and designed for easy installation, this OEM component supports the long-term operation of your cleaner.
-
Critical wheel spacer: Maintains correct spacing between wheel and bearing for smooth, unrestricted movement
-
Debris-blocking design: Acts as a barrier to keep dirt and grit away from sensitive internal bearing surfaces
-
Prevents screw overtightening: Protects wheel hardware from stress or damage caused by excessive torque
-
Used in all wheel assemblies: Each Polaris 180 or 280 unit needs four washers per set for full system balance
-
Simple replacement part: Easy to install during regular service to preserve optimal cleaner operation
- (1) Polaris C64 Wheel Washer
- Polaris Vac-Sweep Cleaner Models: 180, 280





