Find your parts diagram
Sticker on the pump body (the part with the basket), not on the motor. Motor labels from Century, A.O. Smith or Regal won't match parts.
Label on the side of the tank near the base. Size is in sq ft, e.g. 420 sq ft = C4030 or CCP420.
Rating plate inside the front access panel. Note the BTU and gas type (NG or LP).
Molded into the body or printed on top. Robotic cleaners: on the power supply.
Still not sure? Call (818) 818-6559 and we'll find it for you.
Swimables SW-61-190 Cleaner Wheel Retainer Clip Replacement | PVXWLC1900WH
Pickup, delivery and shipping times are estimates, not guarantees.
Couldn't load pickup availability
Have a question about this part?
Ask about fit, specs or shipping and get an instant answer.
Goes with this part
CA P65 Warning: Cancer and reproductive harm. www.p65warnings.ca.gov
Engineered as a direct replacement for Hayward OEM part number PVXWLC1900WH, the Swimables SW-61-190 is a wheel retainer clip built for Hayward Poolvergnuegen 2-wheel and 4-wheel Next Generation suction-side pool cleaners. The retainer clip's job is straightforward but critical — it locks the wheel hub onto the cleaner's axle and keeps it from sliding off during active cleaning cycles, preserving the cleaner's ability to track and cover the pool. Introduced as a modern alternative to the traditional screw-and-washer wheel retention method, this clip-style design requires no tools for installation or removal, snapping into place over the axle to secure the wheel hub in position. When a retainer clip is lost or cracked, the wheel can detach from the axle entirely during operation, stopping cleaner movement and leaving sections of the pool uncleaned until the issue is found and repaired. The SW-61-190 ships in white to match the Poolvergnuegen cleaner body for a clean, consistent finish.
- Drop-In Fit for PVXWLC1900WH: The SW-61-190 wheel retainer clip is dimensionally matched to OEM specifications for the retainer position on Hayward Poolvergnuegen 2-wheel and 4-wheel Next Generation suction-side pool cleaners, allowing the clip to seat properly over the axle without modifications, adapters, or compatibility guesswork during installation.
- Prevents Wheel Loss During Cleaning: The retainer clip's primary job is to hold the wheel hub firmly onto the axle under the constant motion and water pressure of an active cleaning cycle, and replacing a missing or damaged clip with the SW-61-190 eliminates the mid-clean wheel detachment that ranks among the most common failure modes on Poolvergnuegen cleaners.
- Snap-On Install Replaces Screw-and-Washer Method: This clip-style design supersedes the older screw-and-washer wheel retention approach with a tool-free snap-on installation that goes on and comes off in seconds, accelerating wheel hub service significantly for both pool service professionals working busy routes and homeowners performing their own cleaner maintenance.
- White to Match the Cleaner Body: The SW-61-190 is finished in a white colorway specifically chosen to match the Hayward Poolvergnuegen cleaner body, supporting a uniform aesthetic on the cleaner after replacement instead of introducing visibly mismatched hardware that draws the eye during operation in clear pool water.
- Cheap Insurance Against Service Interruption: Because a single missing or cracked retainer clip can cause a wheel to detach mid-cycle and halt cleaning until the cleaner is retrieved and repaired, keeping a spare SW-61-190 on hand is a low-cost preventative step that helps avoid lost cleaning days, especially during the peak pool season.